Vectrex - unique 1982 vector based CRT game console repair
GCE Vectrex(1982)
This rare Vectrex came in with a description “It worked perfectly, then more and more slowly faded away first the audio, then the whole console stopped working during each session after a while until it decided to not turn on anymore at all”.
This is US version of Vectrex so needs a 240v to 110V step-down transformer to operate on. Upon power up, nothing happens. No signs of life.
Diagnosis
Open up the case, discharged the tube, and didn’t find anything obviously wrong.
Tested the transformer, which is supposed to be fail-prone, all good with low impedance.
Tested the power switch, which is also likely to fail. Yes, the power switch doesn’t have continuity at all, albeit it does have a good feeling of “clicking”.
The repair
Tried some cleaning tricks by opening up a little bit from the back and spray contact cleaner. No luck.
I have to open up the switch to see what’s going on. The contacts are shiny, and it does have continuity when I push the contacts together.
The only thing probably went wrong is the plastic knob that moves the grey plastic plate which in turn moves the metal contacts. The knob has worn too much so it cannot provide a good push.
To prove it’s the power switch’s problem, I tried to short the switch and the Vectrex did power on.
But no sound. Since the volume control are from the same potentiometer/switch component, I think first thing is to replace the switch. And the client agreed with the approach.
There isn’t an exact match but the Internet has answer for us. The closest model is TE 23ESA103MMF50AF. It needs some mod to get it fit in, and it isn’t cheap for a power switch.
Specifically, you will need:
- Cut the shaft short
- File the shaft’s diameter down to 6mm
- Enlarge the mounting panel by a small amount, roughly 1mm
- Use jumper wires to connect to the logic board for volume adjustment
Leave a little space between the power switch cap and the logic board holder.
Checking before assembling. Found an issue lasted 44 years: one of the deflection wire on CRT isn’t soldered properly and prone to fail.
Fixed that.
Checked the power rails for -13V, -5V, +5V, checked the audio signal and audio output path, along with the speaker. All good.
Assembled, and powers on.
A fully working Vectrex, with sound.











