The Simpsons - 1991 arcade board no image repair
Konami The Simpsons(1991)
The board arrived in a decent condition, with a few controller and speaker connections soldered directly onto the socket. The client said the image is tearing up.
Diagnosis
Turn the power on, the sound outputs OK, the RGB signals are there but the sync signal is around 4V DC with very little sync triggering drop, about 300mV on scope.
Most the monitor and the supergun’s composite chip didn’t pick this signal up. However when I use RGB and C-Sync(with the very little drop voltage) to a Sony PVM, it does output clear pictures. With that, tried the test menu and all ROMs and music, test, screen are tested fine.
The RGB signals’ voltage level are a lot higher than usual too, suspecting it actually outputs 5V TTL RGB signals. This might cause some CRT issues, with the client says the cabinet’s CRT not working either.
The repair
So it should be a sync signal problem, for the most common monitors.
Confirmed on schematics it is 5V TTL signals.
Confirmed 18E LS367 is bad. Replaced 18E with new LS367, display and sound normal on normal composite monitors.
Desoldered the wires from SOUND connector and two big 3P 4P connectors.
A good clean repaired The Simpsons board.






