Sony CRT Multiscan E200 - non boot CRT repair
SONY CPD E200(2000)
The client sent in this CRT monitor saying it’s stuck in hiccup mode, switch on and off rapidly. “HOT transistor is gone”.
The CRT arrived in overall good condition. Tape can be seen on the VGA connector but no obvious damage from outside.
Diagnosis
Try powering it on. First connect to my bulb current limiter, it does go hiccup but probably the limiter isn’t providing enough current.
Next try disable the limiting function. And I have a blown 3A glass fuse in my limiter. So either this in-rush is too strong, or it’s going to trip the breaker.
The repair
Open the case up, discharged the tube and found an obvious thing.
A blew up capacitor. Surprise?
Check the schematics. This is the main B+ line’s bulk filter capacitor on the SMPS’s secondary wiring. But usually those big caps don’t blow up like this. There could be faults upstream and damaged components in downstream too.
The good news here is we don’t have to find unobtainium like a specific FBT model, at least for now.
So I have to remove the mainboard to find out.
Checked the PCB, overall in good condition, albeit the top is covered in dust.
Checked the surrounding area of the blew up capacitor, no obvious burn marks or cracks. Only the guts of the capacitor were spit onto nearby heatsink. C621 is the capacitor and it’s soldering joints look absolutely fine.
The following the schematics, all the B+ sending 180V circuit has been checked. The rectifiers, coil, over voltage protection silicon controlled rectifier and its voltage divider. Nothing is wrong here.
Then checked the HOT transistor where the client got the impression “HOT transistor is gone”. Because HOT is tied to a transformer too, I will have to desolder at least one leg to test.
HOT and its surrounding components are all good. So this should be only a guesswork. But I do find two sloppy soldering jobs on the line. Way too chunky soldering blobs. Removed them and resoldered one. These are two power resistors connect to the base pin of the HOT transistor.
Tested vertical output IC. No shorts either.
So, it might be just a badly manufactured capacitor went vented? The theory still applies here: when a filtering cap on B+ went bad, it lost its capacitance and had huge ESR, then the filtered voltage can have huge spikes too. The spikes will trip the OVP circuit so that will appear as “hiccups”.
Replaced the bad capacitor with a Rubycon 450V 68uF one. Reinforced with silicon glue.
Rechecked everything and packed up. There are a thousands connectors to put back.
Turned on and… it still blows my current limiter’s fuse. Sigh. Now direct connect it to the wall socket.
And we have a picture. The initial in-rush is the culprit of my blown fuses and this monitor shouldn’t be considered as short in the first place.
The unit is repaired.








