Battle Lane Vol.5 - 1986 arcade graphics glitch repair
Taito Battle Lane Vol. 5(1986)
Boards are grubby. There is a jumper wire broken off.
An intentional cut near the DIP switch, unknown reason.
Powers on, there are dark horizontal lines and dashed lines roughly every 16/32 pixels, probably 4 pixel wide. The main character sprite has glitch too.
Diagnosis
POST screen shows all RAM and ROM tests passed.
First do a ROM verification pass.
- DA03 - DA05 Sprite ROMs: PASSED.
- DA05, DA06 Tile ROMs: PASSED
- 02,L12,L22, CPU and SUB CPU ROMs: PASSED
Tested video output RAM on 6H working as intended. Palette ROM at 7H working even without it(but missing colours). The jumper wire from 9A pin 5/6 to 13A pin 11 is intended, factory botch. So all the purple wires are probably factory.
The repair
Fixed the broken jumper wire. Sprite glitch is fixed. Still gets horizontal dark lines on screen.
Restored the cut using jumper wire near the DIP switch. Still gets horizontal dark lines.
Observed when the top board was covered some vertical glitch will appear. These seems to do with 13F 13H (2x 74LS157) and 13E (TMM2018 RAM). It will make the title glitch at the same time “recover” some of the horizontal line issue.
Piggyback 2x 74LS157 doesn’t make it obviously better. Heat the area up will make the glitch worse.
Observed the dark lines are not just simply “screen overlay”.
- It doesn’t appear at all in POST screen
- The title “Battle Lanes Vol. 5” isn’t affected
- Most graphics in gameplay are affected, but the road dash line covers the horizontal dark lines
- All texts are not affected, they cover the dark lines.
So it’s either BG tile related, or the mix circuitry related.
Tested tile RAM 11D (HM6116), short data bits changes tile, but doesn’t remove horizontal dark lines. The issue could be further up the line.
Try removing two tile ROMs but still have the dark lines so it might be upstream issues.
Poking around the array of TMS4416 RAMs. Those are MOS RAMs having the usual VCC and GND pins flipped, and having a plastic insulator sitting under those chips.
The TMS4416s are talking to the outside via 3x 74LS245 chips.Just a short on the B side of those 74LS245 will crash the game. Short on A side seems to have some effects on the graphics.
Piggyback 1x 74LS245 on 1M, seems that’s the one causing the issue. But removing the piggybacked chip still works for a while?! A marginal 74LS245? The signals look fine though.
With a few more experiments, all I can say is the behaviour is not deterministic. 1J, 1L, 1M 3x 74LS245 might all need replacement.
Replaced 1M, 1J, 1M with 3x new 74LS245. The horizontal dark lines are gone.
Reinforced the jumper wires with glue. The board is declared fixed.











